ACTUALIZACIÓN FIRMWARE DVD-3910. AYUDA

Hola, sabéis si el 1910 se puede actualizar? Y si vale la pena?

Gracias

Iniciado por fgarcia6

Pues éso. El distribuidor de DENON ya me ha enviado los tres discos para actualizar el denon link del DVD-3910. Actualmente el reproductor viene con la 2ª generación y para pasar a la 3ª y poder escuchar SACD y DVD Audio hay que actualizarlo.
Pero, ¿cómo tengo que hacerlo? HAcer el favor de explicarmelo.
Un saludo.

(1) Upgrading to Denon Link 3.
Turn on the dvd player and press OPEN/CLOSE to open the drawer.
Place CD1 in the player and press OPEN/CLOSE.
After closing the drawer the update starts automatically. The display shows “LOADING”. Then it shows “ERASE" and "WRITING”. After a little while the display shows “COMPLETE”. The drawer opens automatically; take CD1 out of the dvd player.

Place CD2 in the drawer, turn the dvd player off and then on again. The drawer closes and the update starts automatically. The display shows “LOADING”, then “WRITING” and finally “COMPLETE”. The drawer opens automatically; take CD2 out of the dvd player.

Place CD3 in the drawer, turn the dvd player off and then on again. The drawer closes and the update starts automatically. The display shows “LOADING”, then “STOP”, “UPDATE”, “ERASE”“WRITING” and finally “COMPLETE”. The drawer opens automatically; take CD3 out of the dvd player.

Remove the SE sticker from the back of the DVD player (under the Denon Link connector).


(2) Turn the dvd player off and then on again.


(3) Confirming the firmware version.
Remove any disk from the player. Turn the player off. Turn the player on while at the same time pressing both “PLAY” and “OPEN/CLOSE” at the front of the player. Keep these buttons depressed for a few seconds. On the remote control then press in sequence “3” “2” “ 6 “ “ 5 “. Then, on the remote control, press “MENU” repeatedly to read out the firmware version.

Version : ESS 6609-B, MakeDay 413D, DRV 030825, SYS 6767-5, DSP 6770 en C20041028.

(4) Procedure for using DENON Link 3rd
Go to "Digital Interface Setup" in the "Setup" menu and set "Denon Link" to "3rd".


Un saludo