Cita Iniciado por Marcuse Ver mensaje
Igual hay alguno que controla de electrónica un huevo, pero la mayoría están moviendo los potenciómetros un poco a boleo. Desde luego lo más sensato es no tocar nada. Pero yo sé que no me voy a poder resistir :/

Respecto a cómo quedan los voltajes después de la modificación, en el post 283 se comenta algo al respecto:

Código:
1. prior to adjustment
 VA 60
 VS 200
 VSC and Vy were 135 and 187 (I can't recall which was which off the top of my head)
 2. The sticker said they were supposed to be:
 VA 60
 VS 201
 VSC and Vy 150 and 180. 
 3. after adjustment I had:
 VA 62
 VS 205
 VSC and Vy 135 and 190
 
 These are of course all interconnected as adjusting one would alter the room for adjustment on the others to varying degrees. 
 The only pot that concerns me is VS as cranking this up beyond about 208  made the set just shut off and it would not restart until I lowered it  back down a bit. 205 was a nice compromise where the set runs fine and  all the noise in near whites is gone. All the other pots did produce  some visual problems like pixel misfires and failed resets but the set  would still run.
No parece que los potenciómetros permitan grandes variaciones, pero habrá que andar con cuidado igualmente.

Saludos.
Marcuse, esas fotos, NI ninguna foto (a no ser la que se tomen para mostrar UN CLARO defecto), NO sirven para nada...

Yo puedo mostrar más de mil así de mi PX con negros que dejarían en ridículo a cualquier Kuro, y claro, más falsas que un Euro de chocolate... No porque se falseen, sino porque la cámara toma la luz de las partes claras y los negros se ennegrecen un montón...

Así que cuidadín...

Saludos