Corto y pego parte del artículo en el enlace:

Note if the mains are set to Large and the subwoofer mode is set to LFE, there is no crossover selection available for the mains. If the mains are set to Large and LFE+Main is selected, then the ‘crossover’ selection becomes available for the mains. This really isn’t a true ‘crossover’ at all, because the mains are still being sent a full-range signal. What the ‘crossover’ becomes when LFE+Main is selected is the low pass filter setting for the duplicate signal being sent to the subwoofer. In this sense, the user can select the amount of ‘overlap’ between the mains and the subwoofer.

This distinction is not well understood by most enthusiasts, nor is it well communicated by the AVR GUI menu. It suggests or implies a crossover is still being applied to the mains when they are set to Large, when in reality that is not the case.

The LPF for LFE is the low pass filter setting for the LFE channel. Normally this is set to 120 Hz, since that is typically the upper limit used by DVD mixing engineers